Usually, when the Cast Aluminum Tubular Heating Element is tested at the factory, sometimes the stainless steel electric heating tube is not working properly, and there is no problem of heat generation after power-on. What caused it? We need to find out the reasons for this to avoid such a situation in production, affecting production quality and production cycle. Let's take a look at the fact that the Stainless Steel 304 Coil Tubular Heater does not heat up after being energized. The main reasons are as follows:
1) The 230V 3KW Spring Tubular Heating Elements resistance wire is disconnected. Since the resistance wire is directly blown off by electric current in a special case or has been destroyed during processing, it may not work properly after being energized.
2) The Electric Stainless Steel Industrial Heating Element terminal is not connected to the resistance wire or connected poorly. At the time of production, when the terminal block is installed, it is not connected to the resistance wire, and the current is different, so that heat cannot be generated.
3) The power supply of the 220V Electric Heating Element Coil Heater is abnormal or the power is off, which causes the 8mm Stainless Steel Warming Oven Heating Element to work.
4) The Coiled Heating Element For Catering Oven power cord plug is in poor contact with the electric heating socket, or the power supply line wire is broken, so that no current flows through the Load bank Tubular Heating Element In Stainless Steel, so that it cannot generate heat.
5) The set temperature of the Tubular Heating Element For Ovens And Furnaces control meter is lower than the current room temperature, so that the solid state relay or the power regulator has no output, so that the Hot Runner Flexible Manifold Tubular Heater is always in the unactivated state, so that the Industrial Rod Heating Elements For Box Furnace can not generate heat.
If the above situation and solution are combined to solve the malfunction of the Resistance Bendable Tubular Heating Element, the production can be better.
In our lives, we can't do without the application of 110V Tubular Heating Elements For Roaster. So what are the precautions about Electric Industrial Spiral Coil Tubular Heating Elements? Do you understand? Let's take a look at it below.
1. When heating nitrates, consider safety measures to prevent explosions.
2, the wiring should be placed in the insulation layer to prevent corrosion, explosive media, in the outer part in contact with water; the wire should be able to withstand the temperature and heating load wiring, the long-term part of the fastening screw should avoid excessive force .
3. The 220V Industrial Spiral Coil Tubular Heater Elements should be stored in a dry place. When the insulation resistance is lower than the long-term placement, if it is 1MΩ, it can be heated in an oven of about 200°C or low-voltage power supply until the insulation resistance is restored.
4. The outlet end of the magnesia powder Electric Grill Tubular Heating Element avoids the infiltration of water with spaces and pollutants to prevent the occurrence of electric leakage accidents.