Problems encountered by Suwaie Industrial Electric Heater
In the process of industrial electric Heater heating water, damage to the Heater often occurs, how to avoid the problem by knowing the principle. In the process of damage to the electric heating element, part of the material of the electric heatingelement is a problem, and part of the damage is caused by human operation. We can buy good quality products to solve the problem of electric heatingtubular materials, but for the part of human operation we need to strengthen the analysis of the cause of damage. According to the consultation and statistics, the materials are as follows:
When boiling water, you need to place the electric heating tubular in a non-conductive object to boil the water, and it must be higher than the heating surface, and do not get water on the connector to prevent leakage. The connector should be kept as clean as possible. It should not be burned out due to lack of water, easy to burn out, breakdown. If the power is high, it can cause the tube to burst. It is necessary to connect the ground and consider the safety issue. If it trips, the moisture in the electric heating element should be dried and then measured with a high-voltage instrument or a megohmmeter. The simplest is a multimeter to measure the leakage (DC power). The leakage should not exceed 50V. If it reaches 110V, it must not be used (it will get an electric shock). Replace it with a new electric heating tube. There is an industrial voltage of 380V or a household 220V. Depending on whether you are using it for household or industrial use, there is a ground wire for industrial use, and a temperature control cabinet is available if necessary. In your home, you just need to turn off the switch or pull the switch. (If necessary, you can use a thermocouple or a thermostat and connect a fuse). Of course, the home kettle is simple. The water is turned off or the switch is opened. Some kettles will power off after boiling, and the water must be higher than the heating surface.